AquaPhalt 6.0 (Medium)
Aquaphalt™ is a revolutionary, high performance, flexible, reactive, cold-mix, asphalt repair product for use in repairing asphalt and concrete road surfaces. Aquaphalt™ reacts with plain water to provide a permanent repair solution. All sizes of Aquaphalt™ are free of solvents or volatile organic compounds (VOCs).
- Easy to use and apply - Cold-mix formulation, water-activated
- No special tools required - Only a manual tamper and a bucket of water
- Cost effective product - Saves time and money by eliminating costly repeat repairs
- All-season product - Can even be installed in below-freezing temperatures
- Surface can be exposed to traffic right away - Full cure in 24 hours
- Permanent and environmentally safe repair solution - VOC- and solvent-free material
Usage
This product can be used on highways (asphalt or concrete), runways/taxiways/aprons, bridge decks, manhole repairs, potholes, utility cuts, parking lots, driveways, tennis courts and pathways.
Advantages
- Easy to use and apply - Cold-mix formulation, water-activated
- No special tools required - Only a manual tamper and a bucket of water
- Cost effective product - Saves time and money by eliminating costly repeat repairs
- All-season product - Can even be installed in below-freezing temperatures
- Surface can be exposed to traffic right away - Full cure in 24 hours
- Permanent and environmentally safe repair solution - VOC- and solvent-free material
Packaging
23 kg (50 lb) pails
FAQ
Each bucket of Aquaphalt™ contains approximately 23 KG (50 lb) of material. Store indoors, in cool, dry conditions. Avoid direct sunlight and/or exposure to freezing. Aquaphalt™ can be applied in freezing conditions, but workability is best when it is stored indoors.
The reactive process happens relatively quickly and AquaphaltTM starts to get hard and in most cases will be fully cured in 24 hours. Since Aquaphalt™ does not release any harmful VOCs, it can be sealed 24 hours after installation.
Aquaphalt™ hardens quickly for immediate use. After water is applied, Aquaphalt™ will start to cure in 15 minutes and can be immediately opened to traffic.
Reactive Binder is a further development of the “RapsAsphalt” technology. “Raps-Asphalt” is a plant-based binder with bitumen (a naturally occurring by product of organic materials), which represents a total weight of approximately 5-8% of the finished product. This binder contains natural rapeseed oil which improves stability. The binder of Aquaphalt™ is a proprietary liquid that similarly contains renewable natural raw materials.
All of the aggregate materials are a crushed granite and are from an approved Virginia DOT source. All of the aggregate materials are from a non-polishing source and have the following properties: ASTM C-127, 128; Specific Gravity: 3.0 % Max.
Remove all loose material from the area to be repaired. Place Aquaphalt™ in the patch and level with a rake or trowel. Allow 1.3 cm (0.5 po) to 2.5 cm (1.0 po) of additional height for compaction. Saturate with water and compact. If the depth of the pothole is greater than 5.1 cm (2.0 po) to 7.6 cm (3.0 po), it is advisable to fill the hole in two layers. In colder weather, a freezing point suppression additive may be added to the water prior to saturation (i.e., road brine, salt water, etc.).
This product can be used on highways (asphalt or concrete), runways/taxiways/aprons, bridge decks, manhole repairs, potholes, utility cuts, parking lots, driveways, tennis courts and pathways.
All sizes of Aquaphalt™ are free of solvents or volatile organic compounds (VOCs). So Aquaphalt™ contains no toxic solvents or VOCs, making it friendlier to the environment.